There are 11 products.
Flash Tune ECU Based Quickshifter Kit With this kit and your flashed ECU you can upshift without letting off the throttle or pulling the clutch! This kit includes everything you will need to utilize your FTECU-flashed ECU’s Quickshifter Input. Kit Includes: QS sensor (push/pull) Rod kit (cutting may be required to fit) Harness to interface to your ECU Note: Red/Yellow is PULL signal, Blue/Green is PUSH signal
Flash Tune 6-Pin Bench Side Harness 6-pin bench harness is made to be used with USB Datalink
Flash Tune 6-Pin Bike Side Harness 6-pin bench harness is made to be used with USB Datalink
Flash Tune Bench ECU Flashing Kit Kit Includes: Flash Tune data link ECU interface USB cable Bench flashing harness to flash your ECU outside of the bike Power supply for bench flashing (compatible with U.S. and Canadian power outlets) FT ECU license to allow unlimited flashes for a single ecu
Flash Tune ECU Based Quickshifter Kit With this kit and your flashed ECU you can upshift without letting off the throttle or pulling the clutch! This kit includes everything you will need to utilize your FTECU-flashed ECU’s Quickshifter Input. Kit Includes: QS sensor (push/pull) Rod kit (cutting may be required to fit) Harness to interface to your ECU Note: Red/Yellow is PULL signal, Blue/Green is PUSH signal
Flash Tune 6-Pin Bench Side Harness 6-pin bench harness is made to be used with USB Datalink
Flash Tune 6-Pin Bike Side Harness 6-pin bench harness is made to be used with USB Datalink
Flash Tune Data Link ECU Flashing Kit Kit Includes: Flash Tune data link ECU interface USB cable Bike-side programming harness to permanently install on your bike FT ECU license to allow unlimited flashes for a single ecu Installation documents are found in the Document Center once logged in to customer account
ECU-Based Quickshifter Harness This harness allows for plug and play installation of most 2-pin quickshifter sensors using a dual-contact type connector.
Flash Tune Data Link ECU Flashing Kit Kit Includes: Flash Tune data link ECU interface USB cable Bike-side programming harness to permanently install on your bike FT ECU license to allow unlimited flashes for a single ecu Installation documents are found in the Document Center once logged in to customer account
Flash Tune Bench ECU Flashing Kit Kit Includes: Flash Tune data link ECU interface USB cable Bench flashing harness to flash your ECU outside of the bike Power supply for bench flashing (compatible with U.S. and Canadian power outlets) FT ECU license to allow unlimited flashes for a single ecu
